...
Click on the “+” to create a Theater. Delete the previous one(s) if you need the outputs.
In the first page of the configurator, you need to define the number of base layer speakers in your room. Make it Use the arrows on top right to match your room layout. Click Next when done.
.
Set your mutliway speakers by using the MultiWay column
Replicate the speakers you need that are assigned the same signal
You can set your Center channel as phantom in case you do not have a Center Speaker. The Center signal will be spread between LF and RF to recreate it in the middle.
You can also set a Subwoofer channel as a Bass Shaker so it will not be seen in Dirac and that channel will receive the full LFE signal unaltered (unless you EQ it afterwards).
In the second page, you need to define the number of height layer speakers in your room. Make it match your room layout. Click Next when doneSame process as before.
In the third page, you need to define the number of top layer speakers in your room. Make it match your room layout. Click Next when doneSame process as before.
In the fourth page, you’ll see a summary of the Theater you just created. Verify it matches your room layout. Click Save to return to the WebUI Theater configuration.
...
If you use multiple speakers for a single channel, click on the “+” under “Replication” for the channel where it is required.
...
If you use multiway speakers, set the according number of ways under the “Multiway” column.
...
Related articles
| Filter by label (Content by label) | ||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|