/
Dirac doesn't see my ISP unit

StormAudio - Knowledge Center

Dirac doesn't see my ISP unit

  1. Ensure the StormAudio ISP is in Dirac Live Calibration Mode.

  2. Navigate to the Main Speakers landing page of the web user interface and select edit on the room you would like to calibrate.

  3. Locate the Dirac button in the upper center of the page and click it. A dialogue window will pop up providing relevant calibration information, scroll down and click Start New Calibration.

  4. Open the Dirac Live Calibration Tool software and select rescan if you do not see the unit.

If the StormAudio isp-host does not show up you can click the IP tab in the upper left corner and manually enter the IP address of the unit.

Related content

Dirac Live Calibration Tool setup
Dirac Live Calibration Tool setup
More like this
ART - Setup Guide
More like this
ART - Troubleshooting
ART - Troubleshooting
More like this
Where can I download the Dirac Live Calibration Tool software?
Where can I download the Dirac Live Calibration Tool software?
More like this
StormAudio x Dirac Live ART
StormAudio x Dirac Live ART
More like this
Adjusting Dirac channels after updating from 3.5r7 firmware
Adjusting Dirac channels after updating from 3.5r7 firmware
More like this

StormAudio - Knowledge Center