/
Enable/Disable the OSD (On-Screen-Display)

StormAudio - Knowledge Center

Enable/Disable the OSD (On-Screen-Display)

Here is where to look for the OSD setting in the WebUI.

Prerequisites

Your ISP must be powered ON, up-to-date and connected to your LAN.

Your ISP must be equipped with a 7+2 eARC HDMI 2.0 (or above) board.

If you have an ISP Elite MK1 using an HDMI board older than the 7+2 eARC, the OSD will not be available in the settings.

Instructions

  1. Access your ISP’s WebUI in installer mode.

  2. Go to the Settings page:

    image-20241107-141751.png
  3. Under the HDMI settings, select the OSD screen format matching your TV or projector display size.

    • Select “Off” if you don’t want to use the OSD.

    • OSD is available and can be enabled for both HDMI outputs independently.

      image-20241107-141838.png

Related articles

Related content

EQ design in the WebUI
EQ design in the WebUI
Read with this
Get your ISP's IP address
Get your ISP's IP address
More like this
Access the WebUI - Configuration
Access the WebUI - Configuration
Read with this
Audio/Video dropouts
Audio/Video dropouts
More like this
Download the system log files
Download the system log files
Read with this
Set IR Presets & Inputs
Set IR Presets & Inputs
More like this

StormAudio - Knowledge Center